Dear Friends, RFF users,
I beg your pardon if I post this "defense" of my cases ! But, to compare
ONLY the various cases prices, without to consider the leather(s) quality,
and even more the HAND stitching, that ONLY most of my cases are
offering, fatally gives a wrong comparation result...
As far as I know, my cases are the LONE around that are HAND STITCHED,
along all the bottom edge perimeter, AND, for the FULL cases, also along all
the long front edges !
I make also a quite less costly model of my cases, that I call "ECO"(nomic),
NOT hand stitched, but still using the same quality leathers either for the
external, and for the inner lining.
Now, after reading some of your useful comments, I decided to design and to
put into production a new model of my FULL cases, NOT hand stitched, that
will be surely a lot less costly... I am willing to make soon a prototype, and to
post it somewhere for your comments, and possible suggestions !
Many thanks, ciao, Luigi
Originally Posted by Bob Parsons
I've found exactly the same problem with the Epson case. You can only use the top half with lenses like the 35mm Summicron or pre asph Summilux without a hood. I wonder which lens the case was designed for, the design doesn't make sense. In addition the top left hand corner of the lower case is cut away at an angle and doesn't extend up to the LCD hinge, giving very little protection. Again there's no obvious reason for this.
I'm afraid mine's been relegated to being an expensive half case