|
Sharpening Question
The bane of my existence...how much is enough. Recently I dusted off an old action that I purchased several years ago (Intellisharpen from Fred Miranda - it a 14 levels of sharpening). It's a very nice action, works great. I'm going to print a couple of 35 mm frames at 12in x 18in based on a pretty good 4000ppi scanner. Is there a way that I can "preview" the amount of sharpening to get the correct look (tight edges, no halos, etc.) using a 72ppi monitor? How is this typically done? Is there any quasi intelligent sharpening program that sets a level based of the size of the end print. Appreciate any thoughts, I appreciate that it's far from an exact science, just looking for tips.
Regards,
keoj
Last edited by keoj : 10-31-2007 at 15:48.
|
Threaded Mode
