Developed two sheets of 4X5 Tri-X today. Note the crop below.
The facts as I know them:
Flim was in holders for 3 plus years.
Tri-X 320 4X5
Developed with a Jobo CPE (constant agitation)
5 minute pre-soak
Developer HC-110 1:50 for 8 minutes
Plain water stop 30 seconds
Kodak fixer 8 minutes
Hypo-eliminator 3 minutes
Wash 6 water changes ~6 minutes
Defects are in small areas of both films.
It does not appear to be dust.
Could it be a temperature issue?
I'm at a loss to explain this. Was it me or the film or the chemistry or something to do with the temperature?